Server Hardware Owner's Manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Drive Bezel
- Opening the System
- Closing the System
- Removing and Installing Blank Drive EMI Fillers
- Cooling Shrouds
- Power Supplies
- Hard Drives
- Diskette Drive
- Optical and Tape Drives
- Expansion Cards
- SAS Controller Card
- RAID Battery
- Configuring the Boot Device
- RAC Card
- Internal USB Memory Key Connector
- Integrated TOE
- Cooling Fans
- System Memory
- Processors
- System Battery
- Chassis Intrusion Switch
- Power Supply Distribution Board
- SAS/SATA Backplane
- Control Panel (Service-only Procedure)
- System Board (Service Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Redundant Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Internal USB Key
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting a SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a Hot-plug Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
68 Installing System Components
Figure 3-3. Removing and Installing a Front Drive Bezel Insert
Opening the System
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the system and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2
Press the power button to ground the system board.
3
Rotate the system feet inward (see Figure 3-4).
1 front drive bezel 2 drive bezel insert
3 tab notch 4 insert tab
5 screws for an optional
5.25-inch drive (3)
1
4
2
5
3