Server Hardware Owner's Manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Drive Bezel
- Opening the System
- Closing the System
- Removing and Installing Blank Drive EMI Fillers
- Cooling Shrouds
- Power Supplies
- Hard Drives
- Diskette Drive
- Optical and Tape Drives
- Expansion Cards
- SAS Controller Card
- RAID Battery
- Configuring the Boot Device
- RAC Card
- Internal USB Memory Key Connector
- Integrated TOE
- Cooling Fans
- System Memory
- Processors
- System Battery
- Chassis Intrusion Switch
- Power Supply Distribution Board
- SAS/SATA Backplane
- Control Panel (Service-only Procedure)
- System Board (Service Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Redundant Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Internal USB Key
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting a SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a Hot-plug Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 149
4
Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
5
Remove the processor shroud. See "Removing the Processor Shroud" on
page 72.
6
Open the drive-carrier release handle on each hard drive and partially
extend the drive(s) out of their drive bays. See "Removing a Hot-plug Hard
Drive" on page 88.
7
Disconnect the following cables from the backplane (see Figure 3-42):
• SAS cable
• Power cable
• Backplane cable
8
Remove the SAS/SATA backplane:
a
Pull the blue backplane release pin. See Figure 3-42.
b
While pulling the release pin, slide the backplane to the left.
c
Pull the backplane board until the securing slots are free from the
securing tabs, and lift the board from the chassis.