Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Jumpers and connectors
This section provides essential and specific information about jumpers and switches. It also describes the connectors on the
various boards in the system. Jumpers on the system board help to disable the system and reset the passwords. To install
components and cables correctly, you must be able to identify the connectors on the system board.
Topics:
• System board connectors
• System board jumper settings
• Disabling a forgotten password
System board connectors
Figure 88. System board jumpers and connectors
1.
BCM5720 on LOM card BTB 2. PCIe Gen 4 x16 Slot 1 / SNAPI
3. Coin cell battery 4. NPIO 2 SATA Connector (NPIO2_PCH_SA0)
5. DIMMs for processor 1 Channels A, B, C, D 6. DIMMs for CPU 2 Channels A, B, C, D
7. Slimeline Connector 1 (SL1_CPU2_PA0) 8. Slimeline Connector 2 (SL2_CPU2_PB0)
9. NIPO 3 PCIe connector (NIPO3_CPU2_PB0) 10. DIMMs for processor 2 channels E, F, G, H
11. Processor 2 12. DIMMs for processor 1 channels E, F, G, H
13. Processor 1 14. NVMe Connector
15. Leak Sensor Connector 16. TPM Connector
17. PCIe Gen 4 x16 Slot 2
System board jumper settings
For information about resetting the password jumper to disable a password, see the Disabling a forgotten password section.
6
82 Jumpers and connectors