Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 77. Removing the OCP card filler
Next steps
1. Install the OCP card.
2. Install the expansion card riser 2.
3. Install the expansion card riser 1.
Installing an OCP card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card riser 1.
4. Remove the expansion card riser 2.
5. Remove the OCP filler.
Steps
1. Align and insert the OCP card into the sled. Slide the OCP card and push firmly until it is fully connected to the system board
connector.
NOTE: Ensure to lift the OCP card retention latch if it is in the lock position.
2. Close the OCP card retention latch to secure the card in place.
70
Installing and removing system components