Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 75. Installing the processor and heat sink (PHM)
3. Set the Anti-Tilt wires to the locked position (outward position), and then using the Torx #T30 screwdriver, tighten the
screws (8 in-lbf) on the heat sink in the order below:
a. Tighten the first screw three turns.
b. Tighten the screw diagonally opposite to the screw you tighten first.
c. Repeat the procedure for the remaining two screws.
d. Return to the first screw to tighten it completely.
68
Installing and removing system components