Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 33. Removing the support bracket
2. Remove the support bracket from the chassis.
Next steps
Replace the support bracket.
Installing the support bracket
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the support bracket with the stand off on the chassis.
2. Using a Phillips #1 screwdriver, tighten the screws that secure the support bracket to the chassis.
30
Installing and removing system components