Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
NOTE: Ensure that the SATA cables are routed behind the air shroud clip.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud until the blue clip locks in place.
Figure 32. Installing the air shroud
Next steps
Follow the procedure listed in After working inside your system.
Support bracket
Removing the support bracket
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the support bracket to the chassis.
Installing and removing system components
29