Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 27. Sled Installation Guidelines
Removing a sled
Prerequisites
Follow the safety guidelines listed in Safety Instructions.
NOTE: The procedure to remove a sled blank or a sled is similar.
Steps
1. Holding the sled handle, press the retention latch on the sled to release the sled.
2. Slide the sled out of the enclosure.
CAUTION: Support the system with both hands while sliding it out of the enclosure.
Installing and removing system components 25