Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 60. Removing the linking board and PCIe cable
4. To disengage the linking board connector, lift and push the MB cable towards the front of the sled.
5. Remove the MB cable from the sled.
Next steps
Replace the linking board and PCIe cable.
Installing the linking board and PCIe cable
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Route the MB cable along the chassis wall.
2. Align the linking board connector with the screw holes on the chassis and using a Phillips #2 screwdriver tighten the captive
screws to secure the linking board cable connector to the chassis.
3. Connect the MB connectors to the connectors on the system board.
Installing and removing system components
55