Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6520 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge C6520 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- LOM riser card
- M.2 SSD module
- Linking board and PCIe cable
- System memory
- Processor and heat sink module
- Optional OCP card
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
3. Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 1 on to the system board.
Figure 39. Installing the expansion card riser 1
Next steps
Follow the procedure listed in After working inside your system.
Removing the expansion card riser 2
Prerequisites
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card riser 1.
Steps
1. Using Phillips #1 screwdriver, remove the screws that secure the expansion card riser 2.
2. Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.
38
Installing and removing system components