Reference Guide
Chassis management board specications
Figure 2. Chassis management board specications
1
Fan cage 1 connector for fans 1 and 2 2 Left midplane signal cable
3 Chassis management board signal cable to backplane 4 Chassis management board power connector from PIB
5 Chassis management board signal cable to PIB 6 FPGA connector
7 MCU connector 8 COM connector
9 Firmware jumpers 10 Right midplane signal cable
11 Fan cage 2 connector for fans 3 and 4
Drives and storage specications
The Dell EMC PowerEdge C6400 enclosure supports SAS and SATA hard drives and Solid State Drives (SSDs).
Table 4. Supported drive options for the
Dell EMC PowerEdge C6400 enclosure
Maximum number of drives in the enclosure Maximum number of drives assigned per sled
12 x 3.5-inch drive systems Three SAS or SATA hard drives and SSDs per sled
24 x 2.5-inch drive systems Six SAS or SATA hard drives and SSDs per sled
24 x 2.5-inch drive systems with NVMe The NVMe backplane supports either of these congurations:
• Two NVMe drives and four SAS or SATA hard drives and SSDs
per sled
• Six SAS or SATA hard drives and SSDs per sled
M.2 SATA drive (optional) The supported capacity of the M.2 SATA card is up to 240 GB
NOTE: The M.2 SATA card can be installed on the x16 riser
slot (slot 5).
8 Technical specications