Error Reference Guide

POST Codes SR870BN4 Error Reference Guide
Revision 1.0
26
Code Value Module Display
0x00D7 Passing control to the interface module next. South
0x00D8 The main system BIOS runtime code will be decompressed next. South
0x00D9 Passing control to the main system BIOS in shadow RAM next. South
0x0003 Next, checking for a soft reset or a power on condition. South
0x0005 The BIOS stack has been built. Next, disabling cache memory. South
0x0006 Uncompressing the POST code next. South
0x0008 The CMOS checksum calculation is done next. South
0x000B Next, performing any required initialization before the keyboard BAT command is
issued.
South
0x000C
The keyboard controller input buffer is free. Next, issuing the BAT command to the
keyboard controller.
South
0x000E The keyboard controller BAT command result has been verified. Next, performing any
necessary initialization after the keyboard controller BAT command test.
South
0x000F The initialization after the keyboard controller BAT command test is done. The
keyboard command byte is written next.
South
0x0010 The keyboard controller command byte is written. Next, issuing the Pin 23 and 24
blocking and unblocking commands.
South
0x0011 Check for INS key pressed. Get POST info. South
0x0012 Disable DMA controllers 1 and 2 and interrupt controllers 1 and 2. South
0x0013 The video display has been disabled. Port B has been initialized. Next, initializing the
chipset.
South
0x0014 The 8254 timer test will begin next. South
0x0019 The 8254 timer test is over. Starting the memory refresh test next. South
0x001A The memory refresh line is toggling. Check the 15-second on/off time next. South
0x0023 Read the 8042 input-port and disable the MEGAKEY Green PC feature next. Make the
BIOS code segment writable and perform any necessary configuration before
initializing the interrupt vectors.
South
0x0024 The configuration required before interrupt vector initialization has completed. Interrupt
vector initialization is about to begin.
South
0x0025 Interrupt vector initialization is done. Clear the password if the POST DIAG switch is
on.
South
0x0027 Any initialization before setting video mode will be done next. South
0x0028 Initialization before setting the video mode is complete. Configuring the monochrome
mode and color mode settings next.
South
0x002A Bus initialization system, static, and output devices will be done next, if present.
Starting LAN redirection, displaying redirection console message.
South
Note that there
will be 15-bit
post codes in
this area. These
indicate Device
Initialization
Manager sub-
codes.
The convention for the DIM POST codes is as follows:
Port 80 = 0x2A
Port 81 = DIM Function number | DI number
South
0x002B Passing control to the video ROM to perform any required configuration before the
video ROM test.
South
0x002C All necessary processing before passing control to the video ROM is done. Look for the
video ROM next and pass control to it.
South
0x002D The video ROM has returned control to BIOS POST. Perform any required processing South