Setup Guide

20 Rack Installation Guide
2 Fit the latch of the ramp assembly on the ramp assembly bracket, located on the opposite side of
the rack from where you attached the cable-management arm (see Figure 1-11).
3 To slide the cable-management arm into place:
a Locate the ramp assembly wireform guide at the bend of the cable-management arm.
b Lift and slide the ramp assembly wireform guide up the ramp, stopping at the ramp assembly
seating catch.
c If you have selected the correct ramp assembly, the wireform guide will seat correctly in the catch
at the top of the ramp assembly each time the system is cycled in the rack. Figure 1-11 shows
the left ramp assembly installed with the cable-management arm attached on the right.
To disengage the cable-management arm ramp assembly, press the ramp assembly release button on
the ramp assembly latch and pull the ramp assembly off the bracket (see
Figure 1-11).
Figure 1-11. Installing the Cable-Management Arm Ramp Assembly
NOTE: In Figure 1-11, the cable-management arm is attached on the right side of the rack and the left cable-
management arm ramp assembly is attached to the left side of the rack. Conversely, if you attach the cable-
management arm on the left side of the rack, attach the right cable-management arm ramp assembly to the right
side of the rack.
6
2
3
4
1
5
1 ramp assembly bracket 2 cable-management arm ramp
assembly latch
3 ramp assembly release button
4 ramp assembly seating catch 5 left cable-management arm
ramp assembly
6 ramp assembly wireform
guide