Users Guide

Table Of Contents

Rack Installation Guide 13

Push the mounting rail forward until the mounting hooks enter their square holes, and then push

down on the mounting-bracket flange until the mounting hooks seat and the push button pops out

and clicks (see Figure 1-5).

At the back of the cabinet, pull back on the mounting-bracket flange until the mounting hooks enter

their square holes, and then push down on the flange until the mounting hooks seat and the push

button pops out and clicks.

Repeat step 1 through step 3 for the mounting rail on the other side of the rack.

NOTE: Ensure that the mounting rails are mounted at the same vertical position on both sides of the rack.

Installing the VersaRails Mounting Rails

NOTE: Ensure that the rotating mounting brackets on the slide assemblies are in the VersaRail configuration.

See Figure 1-6.

At the front of the rack cabinet, position one of the mounting rails so that its mounting-bracket flange

fits between the marks you placed (or numbered locations) on the vertical rails in "Marking the Rack"

on page 9 (see Figure 1-6).

The three holes on the front of the mounting-bracket flange should align with the holes between the

marks you made on the front vertical rail.

Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and lower holes in the mounting-

bracket flange to secure the mounting rail to the front vertical rail.

At the back of the cabinet, pull back on the mounting-bracket flange until the mounting holes align

with their respective holes on the back vertical rail.

Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and lower holes in the mounting-

bracket flange to secure the mounting rail to the back vertical rail.

Repeat step 1 through step 4 for the mounting rail on the other side of the rack.

NOTE: Ensure that the mounting rails are mounted at the same position on the vertical rails on each side

of the rack.