Quick Reference Guide
Table Of Contents
- 6741Utopcover
- 6741Ubk0toc
- 6741Uc10
- 6741Uc20
- 6741Uc30
- 6741Uc40
- 6741Uc50
- 6741Uc60
- 6741Uc70
- Contents
- Checking Inside the Computer
- Safety First—For You and Your Computer
- Opening the Computer Doors
- Removing the Optional Front Bezel
- Removing and Replacing the Expansion- Card Cage
- Removing the Expansion-Card Cage
- Replacing the Expansion-Card Cage
- Inside the Chassis
- Troubleshooting a Wet Computer
- Troubleshooting a Damaged Computer
- Troubleshooting the Battery
- Troubleshooting Redundant Power Supplies
- Removing and Replacing a Power Supply
- Troubleshooting a Cooling Fan
- Troubleshooting Expansion Cards
- Troubleshooting System Memory
- Troubleshooting the Video Subsystem
- Troubleshooting the System Board
- Troubleshooting the Diskette Drive Subsystem
- Troubleshooting a SCSI Tape Drive
- Troubleshooting SCSI Hard-Disk Drives
- Troubleshooting a RAID Controller
- Troubleshooting an Integrated RAID Controller
- Troubleshooting a PERC 2 Card
- 6741Uc80
- Contents
- Installing System Board Options
- Expansion Cards
- Installing an Expansion Card
- Removing an Expansion Card
- Adding Memory
- Memory Upgrade Kits
- DIMM Installation Guidelines
- Performing a Memory Upgrade
- Installing DIMMs
- Removing DIMMs
- Upgrading the Microprocessor or Installing a Secondary Microprocessor
- Removing a Terminator Card
- Installing a Terminator Card
- Removing the SEC Cartridge and Heat Sink Assembly
- Replacing the SEC Cartridge and Heat Sink Assembly
- Activating the Integrated RAID Controller
- Replacing the Battery
- 6741Uc90
- 6741u100
- Contents
- Installing Hard-Disk Drives
- Preparing SCSI Hard-Disk Drives for Installation
- SCSI Hard-Disk Drive Configuration
- Partitioning and Formatting SCSI Hard-Disk Drives
- General Information on Cabling
- Installing SCSI Hard-Disk Drives
- Installing a Dell PowerEdge Expandable RAID Controller Host Adapter Card
- Installing a SCSI Backplane Daughter Card
- Configuring the Boot Device
- 6741u110
- 6741UappendixA
- 6741UsafetyInstructions
- Contents
- Safety Instructions
- Notes, Notices, Cautions, and Warnings
- Safety Caution and Warnings
- Additional Safety Precautions
- General Precautions
- Precautions for Server and Storage Systems
- Precautions for Rack-Mountable Products
- Precautions for Products With Modems, Telecommunications, or Local Area Network Options
- Precautions for Products With Laser Devices
- When Working Inside Your Computer
- Protecting Against Electrostatic Discharge
- Ergonomic Computing Habits
- 6741Upreface
- 6741Ugabbrev
- 6741Ubk0lof
- 6741Ubk0lot
- 6741Ubk0toc
x
Ensure that proper airflow is provided to components in the rack.
Do not step on or stand on any system/component when servicing other
systems/components in a rack.
!"#$%
Observe the following guidelines when working with options:
Do not connect or use a modem or telephone during a lightning storm. There
may be a risk of electrical shock from lightning.
Never connect or use a modem or telephone in a wet environment.
Do not plug a modem or telephone cable into the network interface controller
(NIC) receptacle.
Disconnect the modem cable before opening a product enclosure, touching or
installing internal components, or touching an uninsulated modem cable or jack.
Do not use a telephone line to report a gas leak while you are in the vicinity of the
leak.
&
Observe the following precautions for laser devices:
Do not open any panels, operate controls, make adjustments, or perform proce-
dures on a laser device other than those specified in the product’s
documentation.
Only authorized service technicians should repair laser devices.
Before you remove the computer covers, perform the following steps in the sequence
indicated.
0*)
!*
"''
*