Quick Reference Guide
Table Of Contents
- 6741Utopcover
- 6741Ubk0toc
- 6741Uc10
- 6741Uc20
- 6741Uc30
- 6741Uc40
- 6741Uc50
- 6741Uc60
- 6741Uc70
- Contents
- Checking Inside the Computer
- Safety First—For You and Your Computer
- Opening the Computer Doors
- Removing the Optional Front Bezel
- Removing and Replacing the Expansion- Card Cage
- Removing the Expansion-Card Cage
- Replacing the Expansion-Card Cage
- Inside the Chassis
- Troubleshooting a Wet Computer
- Troubleshooting a Damaged Computer
- Troubleshooting the Battery
- Troubleshooting Redundant Power Supplies
- Removing and Replacing a Power Supply
- Troubleshooting a Cooling Fan
- Troubleshooting Expansion Cards
- Troubleshooting System Memory
- Troubleshooting the Video Subsystem
- Troubleshooting the System Board
- Troubleshooting the Diskette Drive Subsystem
- Troubleshooting a SCSI Tape Drive
- Troubleshooting SCSI Hard-Disk Drives
- Troubleshooting a RAID Controller
- Troubleshooting an Integrated RAID Controller
- Troubleshooting a PERC 2 Card
- 6741Uc80
- Contents
- Installing System Board Options
- Expansion Cards
- Installing an Expansion Card
- Removing an Expansion Card
- Adding Memory
- Memory Upgrade Kits
- DIMM Installation Guidelines
- Performing a Memory Upgrade
- Installing DIMMs
- Removing DIMMs
- Upgrading the Microprocessor or Installing a Secondary Microprocessor
- Removing a Terminator Card
- Installing a Terminator Card
- Removing the SEC Cartridge and Heat Sink Assembly
- Replacing the SEC Cartridge and Heat Sink Assembly
- Activating the Integrated RAID Controller
- Replacing the Battery
- 6741Uc90
- 6741u100
- Contents
- Installing Hard-Disk Drives
- Preparing SCSI Hard-Disk Drives for Installation
- SCSI Hard-Disk Drive Configuration
- Partitioning and Formatting SCSI Hard-Disk Drives
- General Information on Cabling
- Installing SCSI Hard-Disk Drives
- Installing a Dell PowerEdge Expandable RAID Controller Host Adapter Card
- Installing a SCSI Backplane Daughter Card
- Configuring the Boot Device
- 6741u110
- 6741UappendixA
- 6741UsafetyInstructions
- Contents
- Safety Instructions
- Notes, Notices, Cautions, and Warnings
- Safety Caution and Warnings
- Additional Safety Precautions
- General Precautions
- Precautions for Server and Storage Systems
- Precautions for Rack-Mountable Products
- Precautions for Products With Modems, Telecommunications, or Local Area Network Options
- Precautions for Products With Laser Devices
- When Working Inside Your Computer
- Protecting Against Electrostatic Discharge
- Ergonomic Computing Habits
- 6741Upreface
- 6741Ugabbrev
- 6741Ubk0lof
- 6741Ubk0lot
- 6741Ubk0toc
support.dell.com Jumpers, Switches, and Connectors A-3
PASSWD (default) The password feature is enabled.
The password feature is disabled.
ISA_CLR
(default) The configuration settings are retained
at system boot.
The configuration settings are cleared at
next system boot. (If the configuration
settings become corrupted to the point
where the system will not boot, install
the jumper plug and boot the system.
Remove the jumper before restoring the
configuration information.)