Setup Guide

Table Of Contents

8 Getting Started With Your System

Install the Server Modules

Before installing the modules, orient each module so that the upper handle has the logo on it and

"TOP-SIDE" on the module edge faces upward. Press the release latch on the inside of the upper

handle. Pull out the upper and lower handles.

Beginning from left to right, slide the modules into the chassis. When the open handles contact the

chassis front panel, begin to rotate the handles together (the lower handle will close first) until the

lower handle is flush against the module’s front panel. Continue to rotate the upper handle downward

until it is flush against the lower handle. (When the handles are fully closed, the release latch will

secure both handles to the front panel.)