Reference Guide

Port Aggregator Commands 623
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#
show mac address-table
Use the show mac address-table command to show the MAC address table
for a particular aggregator group.
[port-aggregator group <Group id> is an
optional parameter in the command, and if not specified, it shows all the
MAC entries in all the Groups.
Syntax
show mac address-table [port-aggregator group < GroupId >]
• GroupId — Port Aggregator group identifier. (Range: 1-8 or 1-72) On a
standalone switch, it is up to 8. On a stack, it is 1 to (6 x<number of units
in stack). For a stack of 12 units it is 1-72.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#show mac address-table port-aggregator group 2
Aggregator Group: 2
Aging time is 300 Sec
Vlan Mac Address Port Type
-------- --------------------- ------ --------------------
3 0006.2932.814D 1/g2 Static
2CSPC4.XModular-SWUM204.book Page 623 Friday, March 15, 2013 9:24 AM