Reference Guide

Port Aggregator Commands 619
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command is only available if simple mode is enabled.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#lacp static
console(config-aggregator-2)#
minimum active uplinks
Use the minimum active uplinks command to set the minimum number of
uplinks to be active for the Group. For example, if the number of uplink ports
in the group is 2 and the number of internal ports is 4. If the user sets the
minimum active uplink ports to be 2, then both the uplink ports should be
active; otherwise, all the internal ports in the Group will be brought down. By
default, the minimum active uplinks for a Group is 1, which means at least
one uplink port should be active for the Aggregator Group to be active.
Syntax
minimum active uplinks <number of uplinks>
• number of uplinks — Minimum number of uplinks to be active for the
Aggregator Group to be active. (Range: 1-4)
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
2CSPC4.XModular-SWUM204.book Page 619 Friday, March 15, 2013 9:24 AM