Reference Guide

616 Port Aggregator Commands
Command Mode
Port Aggregator mode
User Guidelines
This command is only available in simple mode.
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#add interface te1/0/1
console(config-aggregator-1)#
duplex
Use the duplex command in port aggregator configuration mode to configure
the full/half duplex operation of all member ports in the aggregator
group/zone. To restore the default, use the no form of this command.
Syntax
duplex [half | full]
no duplex
• half — Force half-duplex operation.
•
full — Force full-duplex operation.
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM204.book Page 616 Friday, March 15, 2013 9:24 AM