Reference Guide

Port Aggregator Commands 615
29
Port Aggregator Commands
Port aggregator commands are only available in simple mode. Use the mode
simple command to clear the configuration and enter simple mode. Use the
no mode simple command to clear the config and exit simple mode. This
chapter explains the following
commands:
add interface
Use the add interface command to add member ports to the Aggregator
Group. To remove member ports from the Aggregator Group/Zone, use the
no form of this command.
Syntax
add interface intf-list
no add interface intf-list
• intf-list — List of Ethernet interfaces. Separate nonconsecutive ports with
a comma and no spaces. Use a hyphen to designate a range of ports.
(Range: valid Ethernet interface list or range)
Default Configuration
This command has no default configuration.
add interface negotiation
duplex no lacp
minimum active uplinks
port-aggregator group
mtu disable
show mac address-table
lacp auto
speed
lacp off
vlan
lacp static
–
2CSPC4.XModular-SWUM204.book Page 615 Friday, March 15, 2013 9:24 AM