Reference Guide

508 IP Addressing Commands
console(config)#interface vlan2
console(config-if-vlan2)#ipv6 address dhcp
ipv6 enable (Interface Config)
Use the ipv6 enable command in Interface Config mode to enable IPv6 on a
routing interface. Use the no form of this command to reset the IPv6
configuration to the defaults.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is not enabled by default.
Command Mode
Interface Configuration mode (VLAN, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
show hosts
Use the show hosts command in User EXEC mode to display the default
domain name, a list of name server hosts, and the static and cached list of
host names and addresses. The command itself shows hosts [hostname].
• Host name. (Range: 1–255 characters). The command allows spaces in the
host name when specified in double quotes. For example,
console(config)#snmp-server host "host name"
2CSPC4.XModular-SWUM204.book Page 508 Friday, March 15, 2013 9:24 AM