Reference Guide

434 Ethernet Configuration Commands
show storm-control
Use the show storm-control command in Privileged EXEC mode to display
the configuration of storm control.
Syntax
show storm-control [all | {gigabitethernet unit/slot/port |
tengigabitethernet unit/slot/port
}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following example shows storm control configurations for all valid
Ethernet ports. The second example shows flow control mode status.
console#show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
1/0/2 Disable 5 Disable 5 Disable 5
1/0/3 Disable 5 Disable 5 Disable 5
1/0/4 Disable 5 Disable 5 Disable 5
console#show storm-control
802.3x Flow Control Mode.................... Disable
2CSPC4.XModular-SWUM204.book Page 434 Friday, March 15, 2013 9:24 AM