Reference Guide

Ethernet Configuration Commands 421
show interfaces counters
Use the show interfaces counters command in either User EXEC mode or
Privileged EXEC mode to display Priority Flow Control (PFC) traffic seen by
the interface, including Received PFC Frames and Transmitted PFC Frames
for a given ethernet or port-channel interface.
Syntax
show interfaces counters [gigabitethernet unit/slot/port | port-channel port-
channel-number
| tengigabitethernet unit/slot/port ]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode,Privileged EXEC mode, Config mode and all Config sub-
modes
User Guidelines
This command has no user guidelines.
Example
The following example displays traffic seen by the physical interface:
console>show interfaces counters
Port InOctets InUcastPkts
Port Type The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Admin State Displays whether the port is enabled or disabled.
Field Description
2CSPC4.XModular-SWUM204.book Page 421 Friday, March 15, 2013 9:24 AM