Reference Guide

1782 User Interface Commands
User Guidelines
The selected mode is applied if the user confirms the selection. The selected
mode is applied as the new operational mode after resetting the configuration
to factory defaults.
Simple mode offers a reduced port aggregator functionality suitable for
modular switches that operate in environments where the network regime
does not allow end users to modify switch settings such that network
operations may be affected. The simple mode command set allows the user to
configure switch access functions and the port aggregator functions.
Example
console(config)#mode simple
Switching modes will immediately clear the configuration.
Are you sure you want to continue? (y/n)
quit
Use the quit command in User EXEC mode to close an active terminal
session by logging off the switch.
Syntax
quit
Default Configuration
This command has no default configuration.
Command Mode
User EXEC command mode
User Guidelines
There are no user guidelines for this command.
Example
The following example closes an active terminal session.
console>quit
2CSPC4.XModular-SWUM204.book Page 1782 Friday, March 15, 2013 9:24 AM