Reference Guide

1760 System Management Commands
Parameter Description
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
Parameter Description
ipaddress Valid IP address of the destination host.
hostname
Hostname of the destination host. (Range: 1–158 characters).
The command allows spaces in the host name when specified in
double quotes. For example,
console(config)#snmp-
server host "host name"
initTtl The initial time-to-live (TTL); the maximum number of router
hops between the local and remote system (Range: 0–255).
maxTtl The largest TTL value that can be used (Range:1–255).
maxFail Terminate the traceroute after failing to receive a response for
this number of consecutive probes (Range: 0–255).
interval The timeout period. If a response is not received within this
period of time, then traceroute considers that probe a failure
(printing *) and sends the next probe. If traceroute does receive
a response to a probe, then it sends the next probe immediately.
(Range: 1–60 seconds).
count The number of probes to be sent at each TTL level
(Range:1–10).
port The destination UDP port of the probe. This should be an
unused port on the remote destination system (Range:
1–65535).
size The size, in bytes, of the payload of the Echo Requests sent
(Range: 0–65507 bytes).
src-ip-address The IPv4 source address to use in the ICMP echo request
packets.
vlan A valid VLAN interface.
loop-id A configured loopback ID
2CSPC4.XModular-SWUM204.book Page 1760 Friday, March 15, 2013 9:24 AM