Reference Guide

1756 System Management Commands
Command Mode
Stack Global Configuration
User Guidelines
No specific guidelines.
Examples
console(config)#stack
console(config-stack)#standby 2
switch renumber
Use the switch renumber command in Global Configuration mode to change
the identifier for a switch in the stack. Upon execution, the switch is
configured with the configuration information for the new switch, if any is
available. The old switch configuration information is retained; however, the
old switch will be
operationally unplugged .
Syntax
switch oldunit renumber newunit
• oldunit — The current switch identifier. (Range: 1–6)
•
newunit — The updated value of the switch identifier. (Range: 1–6)
Command Mode
Global Configuration mode
User Guidelines
This command is executed on the Management Switch.
Example
The following example displays how to reconfigure switch number “1” to an
identifier of “2.”
console(config)#switch 1 renumber 2
2CSPC4.XModular-SWUM204.book Page 1756 Friday, March 15, 2013 9:24 AM