Reference Guide

1738 System Management Commands
Example – All Units in the Stack
This example displays information about all units in the stack.
console>show switch
Switch Management Preconfig Plugged-in Switch Code
Status Model ID Model ID Status Version
-------------------------------------------------------------
1 Mgmt Switch PCM8024 PCM8024 1.0.0.0
Switch Type This field displays the 32-bit numeric switch
type.
Model Identifier This field displays the model identifier for this
switch. Model Identifier is a 32-character field
assigned by the switch manufacturer to identify
the switch.
Switch Status This field displays the switch status. Possible
values are OK, Unsupported, Code Mismatch,
Config Mismatch, or Not Present.
Switch Description This field displays the switch description.
Detected Code Version This field displays the version of code running
on this switch. If the switch is not present and
the data is from preconfiguration, the code
version is "None."
Detected Code in Flash This field displays the version of code that is
currently stored in FLASH memory on the
switch. This code will execute after the switch is
reset. If the switch is not present and the data is
from pre-configuration, then the code version is
"None."
SFS Last Attempt Status This field displays the Stack Firmware
Synchronization status.
CPLD Version This field displays the Complex Programmable
Logic Device version.
Serial Number This field displays the Switch serial number.
Up Time This field displays the system up time.
Unit Description
2CSPC4.XModular-SWUM204.book Page 1738 Friday, March 15, 2013 9:24 AM