Reference Guide

1720 System Management Commands
Last 10-second Message Rate...............0 msg/sec
Highest 10-second Message Rate............8 msg/sec
show cut-through mode
Use the show cut-through mode command to show the cut-through mode on
the switch.
Syntax
show cut-through mode
Command Mode
Privileged EXEC, Config mode and all Config sub-modes
Default Configuration
This command has no default configuration.
User Guidelines
No specific guidelines.
Example
Console#show cut-through mode
Current mode : Enable
Configured mode : Disable (This mode is effective on
next reload)
show hardware profile
Use the show hardware profile command in Privileged EXEC mode to display
the hardware profile information for the 40G ports. The user can optionally
specify an interface or all 40G interfaces are displayed.
Syntax
show hardware profile portmode [interface-id]
2CSPC4.XModular-SWUM204.book Page 1720 Friday, March 15, 2013 9:24 AM