Reference Guide

OSPFv3 Commands 1361
show ipv6 ospf stub table
Use the show ipv6 ospf stub table command in Privileged EXEC mode to
display the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Syntax
show ipv6 ospf stub table
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console#show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
------------ ------------- ---------- -----------------
0.0.0.10 Normal 1 Enable
show ipv6 ospf virtual-links
Use the show ipv6 ospf virtual-links command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all areas in the system.
Syntax
show ipv6 ospf virtual-link [ area-id neighbor-id | brief]
• area-id — Identifies the OSPF area whose virtual interface information is
being displayed.
•
neighbor-id — Router ID of neighbor.
2CSPC4.XModular-SWUM204.book Page 1361 Friday, March 15, 2013 9:24 AM