Reference Guide

636 Port Channel Commands
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp port-priority 247
lacp system-priority
Use the lacp system-priority command in Global Configuration mode to
configure the Link Aggregation system priority. To reset to default, use the no
form of this command.
Syntax
lacp system-priority value
no lacp system-priority
• value — Port priority value. (Range: 1–65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the system priority to 120.
console(config)#lacp system-priority 120
lacp timeout
Use the lacp timeout command in Interface Configuration mode to assign an
administrative LACP timeout. To reset the default administrative LACP
timeout, use the no form of this command.
Syntax
lacp timeout {long | short}
2CSPC4.XModular-SWUM204.book Page 636 Friday, March 15, 2013 9:24 AM