Reference Guide

1754 System Management Commands
User Guidelines
This command has no user guidelines. If not stack configuration appears in
the saved config, it is built at runtime and appears in the running config. The
operator can save the stack configuration. Stack members that do not match
the saved config after a reboot will show a config mismatch and do not join
the stack.
Example
The following example sets the mode to Stack Global Config.
console(config)#stack
console(config-stack)#
stack-port
NOTE: All of the stack-port commands in Stack Configuration mode
are not supported by the PCM8024 and PCM8024-k switches.
Use the stack-port command in Stack Configuration mode to configure ports
as either Stacking ports or as Ethernet ports. This command is used to
configure Ethernet ports to operate as either stacking or Ethernet ports.
Syntax
stack-port {fortygigabitethernet|tengigabitethernet} unit/slot/port {ethernet
| stack}
Default Configuration
By default, Ethernet ports are configured to operate in Ethernet mode.
Command Mode
Stack Configuration mode
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when changing between stacking and
Ethernet mode.
2CSPC4.XModular-SWUM204.book Page 1754 Friday, March 15, 2013 9:24 AM