Reference Guide

Command Groups 128
IPv6 Routing
show ip interface Displays all pertinent information about the IP
interface.
PE
show ip protocols Displays the parameters and current state of the
active routing protocols.
PE
show ip route Displays the routing table. PE
show ip route preferences Displays detailed information about the route
preferences.
PE
show ip route summary Shows the number of all routes, including best
and non-best routes.
PE
show ip traffic Displays IP statistical information. UE or
PE
show ip vlan Displays the VLAN routing information for all
VLANs with routing enabled.
PE
show routing heap summary Displays a summary of the memory
allocation from the routing heap.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 81.
Command Description Mode
a
clear ipv6 neighbors Clears all entries in the IPv6 neighbor table
or an entry on a specific interface.
PE
clear ipv6 statistics Clears IPv6 statistics for all interfaces or for a
specific interface, including loopback and
tunnel interfaces.
PE
ipv6 address Configures an IPv6 address on an interface
(including tunnel and loopback interfaces).
IC
ipv6 enable Enables IPv6 routing on an interface
(including tunnel and loopback interfaces)
that has not been configured with an explicit
IPv6 address.
IC
ipv6 hop-limit Configures the hop limit used in IPv6 PDUs
originated by the router.
GC
Command Description Mode
a
2CSPC4.XModular-SWUM204.book Page 128 Friday, March 15, 2013 9:24 AM