Reference Guide

1182 Multicast Commands
show ip mcast mroute source
Use the show ip mcast mroute source command in Privileged EXEC mode to
display the multicast configuration settings such as flags, timer settings,
incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the
sourceipaddr or sourceipaddr | groupipaddr pair value(s).
Syntax
show ip mcast mroute source sourceipaddr {summary | groupipaddr }
• sourceipaddr — IP address of source.
•
groupipaddr — IP address of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays multicast configuration settings.
console#show ip mcast mroute source 10.1.1.1 summary
console#show ip mcast mroute source 10.1.1.1 224.5.5.5
show ip mcast mroute static
Use the show ip mcast mroute static command in Privileged EXEC mode to
display all the static routes configured in the static mcast table if it is
specified or display the static route associated with the particular
sourceipaddr .
2CSPC4.XModular-SWUM204.book Page 1182 Friday, March 15, 2013 9:24 AM