Command Line Interface Guide

Command Groups 95
interface out-of-band Brings up the OOB port configuration menu. GC
ip address (Out-of-Band) Sets an IP address for the service port. IC
ip address-conflict-detect
run
Triggers the switch to run active address conflict
detection by sending gratuitous ARP packets for
IPv4 addresses on the switch.
GC
ip address dhcp (Interface
Config)
Acquires an IP address on an interface from the
DHCP server.
IC
ip default-gateway Defines a default gateway (router). GC
ip domain-lookup Enables IP DNS-based host name-to-address
translation.
GC
ip domain-name Defines a default domain name to complete
unqualified host names.
GC
ip host Configures static host name-to-address
mapping in the host cache.
GC
ip name-server Configures available name servers. GC
ipv6 address (Interface
Config)
Sets the IPv6 address of the management
interface.
IC
ipv6 address (OOB Port) Sets the IPv6 prefix on the out-of-band port. IC
ipv6 address dhcp Enables the DHCPv6 client on an IPv6
interface.
IC
ipv6 enable (Interface
Config)
Enables IPv6 on the management interface. GC
ipv6 enable (OOB Config) Enables IPv6 operation on the out-of-band
interface.
IC
ipv6 gateway (OOB
Config)
Configures the address of the IPv6 gateway. IC
show hosts Displays the default domain name, a list of
name server hosts, static and cached list of host
names and addresses.
UE
show ip address-conflict Displays the status information corresponding
to the last detected address conflict.
UE or
PE
show ip helper-address Displays the ip helper addresses configuration. PE
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 95 Monday, October 3, 2011 2:21 PM