Command Line Interface Guide

FIP Snooping Commands 865
Example
The following example configures an interface to be connected to an FCF
switch.
(config)# interface te1/0/1
(config-vlan)# fip-snooping port-mode fcf
show fip-snooping
Use the show fip-snooping sessions command in User EXEC or Privileged
EXEC mode to display information about the global FIP snooping
configuration and status.
Syntax
show fip-snooping
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC
User Guidelines
The following information is displayed.
Parameter Description
Global Mode FIP snooping configuration status on the switch. It displays
Enable when FIP snooping is enabled on the switch and
Disable when FIP snooping is disabled on the switch.
FCoE VLAN List List of VLAN IDs on which FIP snooping is enabled.
FCFs Number of FCFs discovered on the switch.
ENodes Number of Enodes discovered on the switch.
Sessions Total virtual sessions on the switch.
2CSPC4.XModular-SWUM201.book Page 865 Monday, October 3, 2011 2:21 PM