Command Line Interface Guide

Data Center Bridging Commands 849
User Guidelines
Interface configuration overrides the global configuration on the designated
interface.
Example
The following example configures the port to transmit all TLVs.
console(interface-config)#no lldp tlv-select dcbxp
lldp dcbx port-role
Use the lldp dcbx port-role command in Interface Configuration mode to
configure the port role to manual, auto-upstream, auto-downstream and
configuration source. The default port role is manual.
Syntax
lldp dcbx port-role {auto-up |auto-down | manual | configuration-source}
Parameter Description
Parameter Description
Manual Ports operating in the ‘Manual’ role do not have their
configuration affected by peer devices or by internal
propagation of configuration. These ports will advertise their
configuration to their peer if DCBX is enabled on that port.
The willing bit is set to disabled on manual role ports.
Auto-up Advertises a configuration, but is also willing to accept a
configuration from the link-partner and propagate it internally
to the auto-downstream ports as well as receive configuration
propagated internally by other auto-upstream ports. These
ports have the willing bit enabled. These ports should be
connected to FCFs.
Auto-down Advertises a configuration but is not willing to accept one from
the link partner. However, the port will accept a configuration
propagated internally by the configuration source. These ports
have the willing bit set to disabled. Selection of a port based
upon compatibility of the received configuration is suppressed.
These ports should be connected to a trusted FCF.
2CSPC4.XModular-SWUM201.book Page 849 Monday, October 3, 2011 2:21 PM