Command Line Interface Guide

848 Data Center Bridging Commands
Example
The following example configures the switch to use CEE DCBX.
s1(config)#lldp dcbx version cee
lldp tlv-select dcbxp
Use the lldp tlv-select dcbxp command in Interface Configuration or Global
Configuration mode to send specific DCBX TLVs if LLDP is enabled to
transmit on the given interface. If no parameter is given, all DCBX TLVs are
enabled for transmission. The default is all DCBX TLVs are enabled for
transmission. If executed in interface mode, the interface configuration
overrides the global configuration for that interface. Entering the command
with no parameters enables transmission of all TLVs.
The no form of the command disables LLDP from sending all or individual
DCBX TLVs even if LLDP is enabled for transmission on the given interface.
Syntax
lldp tlv-select dcbxp [ pfc | application-priority]
no lldp tlv-select dcbxp [ pfc | application-priority]
Parameter Description
Default Configuration
The default value is to transmit all TLVs as enabled by the auto-configuration
port role. In manual mode, the default is to transmit all TLVs.
Command Mode
Interface Config, Global Config
Parameter Description
pfc Transmit the PFC configuration TLV.
application-priority Transmit the application priority TLV.
2CSPC4.XModular-SWUM201.book Page 848 Monday, October 3, 2011 2:21 PM