Command Line Interface Guide

846 Data Center Bridging Commands
datacenter-bridging
Use the datacenter-bridging command for an ethernet interface in order to
enter the DataCenterBridging mode. Priority-Flow-Control is configurable
from within the DataCenterBridging mode.
Syntax
datacenter-bridging
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console#config
console(config)#interface range ethernet all
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority
1 no-drop
lldp dcbx version
Use the lldp dcbx version command in Global Configuration mode to
configure the administrative version for the Data Center Bridging Capability
Exchange (DCBX) protocol. This command enables the switch to support a
specific version of the DCBX protocol or to detect the peer version and match
lldp tlv-select dcbxp show lldp dcbx
2CSPC4.XModular-SWUM201.book Page 846 Monday, October 3, 2011 2:21 PM