Command Line Interface Guide

Command Groups 77
LLDP Configures and displays LLDP information.
Port Aggregator Provides server administrators the ability to map internal
ports to external ports easily.
Port Channel Configures and displays Port channel information.
Port Monitor Monitors activity on specific target ports.
QoS Configures and displays QoS information.
Radius Configures and displays RADIUS information.
Spanning Tree Configures and reports on Spanning Tree protocol.
TACACS+ Configures and displays TACACS+ information.
VLAN Configures VLANs and displays VLAN information.
802.1x Configures and displays commands related to 802.1x
security protocol.
Data Center Technology Commands
Data Center Bridging
Commands
Data Center Bridging Exchange Protocol (DCBX) is used
by DCB devices to exchange configuration information
with directly connected peers. The protocol is also used to
detect misconfiguration of the peer DCB devices and,
optionally, for configuration of peer DCB devices.
FIP Snooping
Commands
FCoE Initialization Protocol (FIP) is used to perform the
functions of FC_BB_E device discovery, initialization and
maintenance. FIP snooping is a frame inspection method
used by FIP Snooping Bridges to monitor FIP frames and
apply policies based upon the L2 header information in
those frames, following recommendations in Annex C of
FC_BB_5 Rev 2.00
Priority Flow Control
Commands
Provides priority-based flow control that can pause
(inhibit transmission of) individual priorities within a
single physical link.
Layer 3 Commands
ARP (IPv4) Manages Address Resolution Protocol functions.
Table 1-1. System Command Groups
(continued)
Command Group Description
2CSPC4.XModular-SWUM201.book Page 77 Monday, October 3, 2011 2:21 PM