Command Line Interface Guide

Port Channel Commands 621
Example
The following example configures the system priority to 120.
console(config)#lacp system-priority 120
lacp timeout
Use the lacp timeout command in Interface Configuration mode to assign an
administrative LACP timeout. To reset the default administrative LACP
timeout, use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
• long — Specifies a long timeout value.
•
short — Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example assigns an administrative LACP timeout for port 1/0/8
to a long timeout value.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp timeout long
2CSPC4.XModular-SWUM201.book Page 621 Monday, October 3, 2011 2:21 PM