Command Line Interface Guide

Port Channel Commands 619
lacp port-priority
Use the lacp port-priority command in Interface Configuration mode to
configure the priority value for physical ports. To reset to default priority
value, use the no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
• value — Port priority value. (Range: 1–65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the priority value for port 1/0/8 to 247.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp port-priority 247
lacp static
Use the lacp static command to set the LACP (Link Aggregation) mode to
static for that Aggregator Group. This means that when more than one uplink
port is in the Group, those uplink ports will be enabled automatically with
static LACP.
Syntax
lacp static
2CSPC4.XModular-SWUM201.book Page 619 Monday, October 3, 2011 2:21 PM