Command Line Interface Guide

556 iSCSI Optimization Commands
• When a port is already defined and not bound to an IP address, and you
want to bind the port to an IP address, first remove the port by using the
no form of the command and then add it again, this time together with
the relevant IP address.
• Target names are only for display when using the show iscsi command.
These names are not used to match (or for doing any sanity check) with
the iSCSI session information acquired by snooping.
• A maximum of 16 TCP ports can be configured either bound to IP or not.
Example
The following example configures TCP Port 49154 to target IP address
172.16.1.20.
console(config)#iscsi target port 49154 address
172.16.1.20
show iscsi
Use the show iscsi command in Privileged EXEC mode to display the iSCSI
configuration.
Syntax
show iscsi
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the iSCSI configuration.
console#show iscsi
2CSPC4.XModular-SWUM201.book Page 556 Monday, October 3, 2011 2:21 PM