Command Line Interface Guide

IP Addressing Commands 505
ipv6 gateway (OOB Config)
Use the ipv6 gateway command in Interface (out-of-band) Config mode to
configure the address of the IPv6 gateway. The gateway is used as a default
route for packets addressed to network devices not present on the local
subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6 gateway ipv6-address
no ipv6 gateway
Parameter Description
Default Configuration
By default, no IPv6 gateway is configured.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.
show hosts
Use the show hosts command in User EXEC mode to display the default
domain name, a list of name server hosts, and the static and cached list of
host names and addresses. The command itself shows hosts [hostname].
• Host name. (Range: 1–255 characters). The command allows spaces in the
host name when specified in double quotes. For example,
console(config)#snmp-server host "host name"
Parameter Description
ipv6-address An IPv6 address (not a prefix).
2CSPC4.XModular-SWUM201.book Page 505 Monday, October 3, 2011 2:21 PM