Command Line Interface Guide

504 IP Addressing Commands
Default Configuration
IPv6 is not enabled by default.
Command Mode
Interface Configuration mode (VLAN, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
ipv6 enable (OOB Config)
Use the ipv6 enable command in Interface (out-of-band) Config mode to
enable IPv6 operation on the out-of-band interface. Prefixes configured by
the ipv6 adddress command are not configured until the interface is enabled.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.
2CSPC4.XModular-SWUM201.book Page 504 Monday, October 3, 2011 2:21 PM