Command Line Interface Guide

502 IP Addressing Commands
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
configuration or DHCPv6 is not enabled on any of the in-band management
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the
in-band management interfaces.
ipv6 address dhcp
Use the ipv6 address dhcp command in Interface (VLAN) Configuration
mode to enable the DHCPv6 client on an IPv6 interface.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Parameter Description
This command does not require a parameter description.
eui64 Formulate the prefix in EUI-64 format.
autoconfig Perform IPv6 auto-configuration.
dhcp Obtain the prefix via DHCP.
Parameter Description
2CSPC4.XModular-SWUM201.book Page 502 Monday, October 3, 2011 2:21 PM