Command Line Interface Guide

IP Addressing Commands 499
ip name-server
Use the ip name-server command in Global Configuration mode to define
available IPv4 or IPv6 name servers. To delete a name server, use the no form
of this command.
Syntax
ip name-server server-address1 [ server-address2 … server-address8 ]
no ip name-server [
server-address1 … server-address8 ]
• server-address —Valid IPv4 or IPv6 addresses of the name server. (Range:
1–255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple
commands. Use the show hosts command on page 505 to display the
configured name servers.
Example
The following example sets the available name server.
console(config)#ip name-server 176.16.1.18
ipv6 address (Interface Config)
Use the ipv6 address command to set the IPv6 address of the management
interface. Use the no form of this command to reset the IPv6 address to the
default.
2CSPC4.XModular-SWUM201.book Page 499 Monday, October 3, 2011 2:21 PM