Command Line Interface Guide

428 Ethernet Configuration Commands
Examples
The following example shows storm control configurations for all valid
Ethernet ports. The second example shows flow control mode status.
console#show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
1/0/2 Disable 5 Disable 5 Disable 5
1/0/3 Disable 5 Disable 5 Disable 5
1/0/4 Disable 5 Disable 5 Disable 5
console#show storm-control
802.3x Flow Control Mode.................... Disable
shutdown
Use the shutdown command in Interface Configuration mode to disable an
interface. To restart a disabled interface, use the no form of this command.
Syntax
shutdown
no shutdown
Default Configuration
The interface is enabled.
Command Mode
Interface Configuration (Ethernet, Port-Channel, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM201.book Page 428 Monday, October 3, 2011 2:21 PM