Command Line Interface Guide

System Management Commands 1655
Default Configuration
This command has no default configuration.
User Guidelines
No specific guidelines.
Example
Console#show cut-through mode
Current mode : Enable
Configured mode : Disable (This mode is effective on
next reload)
show interfaces advanced firmware
Use the show interfaces advanced firmware command to display the firmware
revision of the PHY for a port.
Syntax
show interfaces advanced firmware interface
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
This command is only applicable to 10G non-stacking interfaces.
Parameter Description
interface A 10G non-stacking physical interface.
2CSPC4.XModular-SWUM201.book Page 1655 Monday, October 3, 2011 2:21 PM