Command Line Interface Guide

1644 System Management Commands

console(config-if)#ip address dhcp

Use the login-banner command to enable login banner on the console, telnet

or SSH connection. To disable, use the no form of the command.

Syntax

no login-banner

•

MESSAGE

— Quoted text

Default Configuration

This command has no default configuration.

Command Mode

Line Configuration

User Guidelines

This command has no user guidelines.

Example

console(config-telnet)# no login-banner

member

Use the member command in Stack Global Configuration mode to pre-

configure a switch stack member. Execute this command on the Management

Switch. To remove a stack-member configuration from the stack, use the no

form of the command.

NOTE: The "no" form of the command may not be used if the member is present in

the stack.

Syntax

member

unit

switchindex

2CSPC4.XModular-SWUM201.book Page 1644 Monday, October 3, 2011 2:21 PM